project "Tall Monkey"

So as you readers may or may not have read that Dustin and I (Bret) were going to install some risers and pivot adapter to my rev 800.  Well we did it the other day.  Dustin should have some vids up soon.  The project went well for the most part one broken drill bit and no split knuckles so I think that is a good project.  We did run into a small hang up on the throttle extension part though.  Not quite sure what the problem is yet.  Maybe the part I bought is defective.  the next time I get a chance to work on it I will figure out what the problem is.  But at this point the sled is standing tall but standing still till things are resolved.  

Stay tuned later on this month for hand guards and rear foot rest install.

until then
brap brap

Bret